Welcome to the SeeMeCNC Community

Is it still recommended to run the script after the autocalibration (SeeMeCNC's delta calibration wizard), or is the script now built into the wizard? My first layer is thick at the bottom left of the bed, and thin at the top right.

So I have made the endstop adjustments. X=0, Y=1, Z=3, but the unlevel bed remains unchanged.

I have also run the bed PID auto tune and the heating problem persists.

I had similar problems show up a few weeks after converting my V2 to the HE280 hot end. It could not maintain temperatures above 200 something when the bed was also on. I tried a different power supply (my own lab supply) I had and that fixed the problem. I talked to tech support and they said it s...

Thanks, Djarmag. I will investigate the autocal improvement that you posted.

Eric, I found the history. Thank you!

In the Repetier folder in the Github repository, there is a rostockv3.hex file. What is it for? The repetier.ino file is what the Rambo is populated with, using Arduino IDE. Second, I notice that the firmware for the Rostock Max V3 was updated on Feb 1st, 2017, but see no notes on changes made. Is t...

You put the tape between the thermistor and the glass? I would think that it would be better to get the temp from the glass than the bed ring, since it is the glass that the filament is sitting on?