Welcome to the SeeMeCNC Community

I have been loving this machine after the upgrade. There're two things I'm still trying to work out though. The first is that the pressure in the bowden tube is lost during retraction causing a little underextrusion at the beginning of some paths. The second is accuracy. It's close but not quite the...

Pully grub screws!!! Apparently I forgot to lock tight the threads.

So I have successfully upgraded to the v3.2 and had 2 successfully benchies printed. I noticed my belts where a little loose. So I tightened them a little and I made the mistake of running the first probe instead of just probe and now I can't get the bed level. I try the same benchy and just the foo...

I think I got it but I'm getting height map error and it says I'm using S parameters when I should be using H parameters. I have no idea how to change that.

I can actually update the firmware now but after doing so I try going try first probe and it gives me more errors.

I have successfully installed the board the motors the new hot end and now I'm doing the firmware. I used rostock max v3.2 master files. I try to update firmware with M997 S0:1 and it gives me an error. None of the movement controls work if I try probing or just trying to move on an axis. I'm not su...

I did initially. They directed me here. I setup an account and awaited the account approval. While waiting they responded via email again stating they could throw together a kit for me. I replied accepting that offer.

I'm sure it will all come together eventually.

I have been in contact with someone from SeeMeCNC and they offered to put together a conversion kit last week. I accepted this offer and haven't heard anything since.

I was just wondering if this is still possible?
I have already purchased the motors and board!