Welcome to the SeeMeCNC Community

Hey All,

I thought many of you might be interested to know that Warner Berry (BerryBot Maker) is now selling some of the more desirable parts from his setup.

You can buy:

1) Magnetic Arms
2) End Effectors
3) Steppers
4) Ball Magnets and Machined End Caps
5) and so on......

Check him out at http://www.shopspt.com" onclick="window.open(this.href);return false;

I am not affiliated with him in any way, I am just a subscriber to his Youtube channel and this new site address was on his last video. Not having access to the machining equipment myself, I sure appreciate it when people like Warner who do make products I can use.

Enjoy..........

Thanks for the link, I can see that these are quality parts.
Do you know if the BerryStruder handles 1.75mm filament?

Would using the magnetic joints, the rods, and effector platform they sell cause the need to change the firmware for a Rostock Max V2? or would you just recalibrate and thats it?

If the geometry doesn't change (i.e. the length of the arms and the carriage/effector offsets) you'd just need to recalibrate to dial in the finer adjustments like horizontal radius and you'd be up and printing in no time.

They're not bolt-on parts, though. It would be a custom job.