does anybody have a starting Rostock max v2 config.g file

Northspire · Post by **Northspire** » Sat Mar 04, 2017 10:26 pm

I have tried to config my v2 with the kossell file in the firmware but it tries to commit suicide. Anybody have a starting config.g file I will up load the config I am using also.

Xenocrates · Post by **Xenocrates** » Sun Mar 05, 2017 12:45 pm

Mine is pretty non-standard, but you can try starting with it.

Northspire · Post by **Northspire** » Mon Mar 06, 2017 11:48 pm

ok I got it working but I can't do a auto config. The printer tries to do one but it's 6 inches above the bed and it grinds the belts so I hit the emergency stop button. Any Ideas? I do have the mini ir sensor.

dc42 · Post by **dc42** » Tue Mar 07, 2017 2:35 am

Have you read the page https://duet3d.com/wiki/Calibrating_a_delta_printer ?

Welcome to the SeeMeCNC Community

does anybody have a starting Rostock max v2 config.g file

does anybody have a starting Rostock max v2 config.g file

Re: does anybody have a starting Rostock max v2 config.g file

Re: does anybody have a starting Rostock max v2 config.g file

Re: does anybody have a starting Rostock max v2 config.g file