Hello, first off I don't usually post, I am able to find what I need by searching the forum, but not this time.
Calibrating max v2 with duet3dwifi, I make adjustments for my x,y, axis, get them where I want them using the M579 command, save using M500.
They stay till I power down. I did put the M501 at the end of config.g.
Am I using the right commands,or is there a proper sequence of operation.
Machine takes and uses what I put in (M579), changes are made to test piece, just lose it after power off.
Rostock Max V2
Duet3d wifi
fsr's
3dv6 hotend
Thank You
Carl
M579
Re: M579
\o/
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects