OctoPrint w/ Raspberry Pi Zero?
OctoPrint w/ Raspberry Pi Zero?
After building a new printer, I seem to not have enough funds to get big upgrades for my Rostock. I want to add Octoprint capability at the lost cost of 5 dollars (give or take a few bucks). My question is, can the Raspberry Pi Zero be used for this? Can I use Geneb's delta calibration on this setup?
Re: OctoPrint w/ Raspberry Pi Zero?
I wish I could answer that, but I don't have a Pi Zero. Sorry!
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
-
- Plasticator
- Posts: 15
- Joined: Fri Mar 06, 2015 2:18 pm
Re: OctoPrint w/ Raspberry Pi Zero?
At first blush I don't see why not. The Zero W, ($10) would be easier as it has wireless on board, and would save you needing a USB hub and wireless dongle.
I don't think you could run Octoprint in desktop mode on it, but standard mode shouldn't be a problem.
The calibration script is a simple gcode input, so the flavor of pi shouldn't really matter.
I don't think you could run Octoprint in desktop mode on it, but standard mode shouldn't be a problem.
The calibration script is a simple gcode input, so the flavor of pi shouldn't really matter.