Fitting SE300 to Rostock Max v3 WITHOUT replacing RAMBo

The new for 2016 RostockMAX v3!
Post Reply
forknuts
Noob
Posts: 1
Joined: Sat Jun 29, 2019 6:48 pm

Fitting SE300 to Rostock Max v3 WITHOUT replacing RAMBo

Post by forknuts »

Hi there. I am wondering if anyone knows of any guides or walk-throughs that would help me switch a Rostock v3 Max from a SE280 to an SE300 hotend. WITHOUT replacing/changing the RAMBo for a Duet? I know the SE300 won't be fully functional without the Duet, but I have an SE300 at hand ready to install, and would like to get the printer up and running quickly (i.e. without waiting for a Duet to be delivered).

I have seen it done, but I'm unable to contact the person who did it, and I'm not clever enough to figure the wiring - I really just need advice on where the wires from the SE300 hotend whip would go on the RAMBo board.

Thanks in advance!
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Fitting SE300 to Rostock Max v3 WITHOUT replacing RAMBo

Post by geneb »

Are you aware that if you do this, you won't have any auto-calibration ability at all?

If at all possible, get a Duet. The improvement over the RAMBo is astonishing.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “RostockMAX v3”