SE300 Heater Power Problem

The new for 2016 RostockMAX v3!
Post Reply
ROvermeyer
Plasticator
Posts: 14
Joined: Sat Sep 10, 2016 11:14 pm

SE300 Heater Power Problem

Post by ROvermeyer »

I built a Max V3, which I upgraded to a V3.2. The SE300 had the hotend power problem where it overheated the power connector for the hotend heater. I installed the SE300 Power Connector Upgrade Kit to fix this problem. I am again having hotend power problems and I found that the new power connector on the circuit board is broken, see attached photo. I see that SEEMECNC no longer sells the upgrade kit. Does anyone know what the part number of the 2 pin Molex receptcale is?

Thanks

20201103_140419.jpg
20201103_140419.jpg (272.69 KiB) Viewed 3285 times
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: SE300 Heater Power Problem

Post by geneb »

Contact support, they can help you out with that.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
ROvermeyer
Plasticator
Posts: 14
Joined: Sat Sep 10, 2016 11:14 pm

Re: SE300 Heater Power Problem

Post by ROvermeyer »

geneb,

I posted this here and contacted support, support has responded.

Thanks.

Bob O.
Post Reply

Return to “RostockMAX v3”