Page 1 of 1
Simplify3D Settings
Posted: Thu Nov 19, 2020 10:43 am
by PhantamaroK
Would any kind soul be willing to share their Simplify3D settings? At this point I'm throwing darts at the wall with regard to retraction, etc. and would love to use someone else's common settings as a base.
Re: Simplify3D Settings
Posted: Fri Nov 20, 2020 8:36 am
by geneb
Try the files in the attached zip. There are profiles for a number of materials & machines.
g.
Re: Simplify3D Settings
Posted: Fri Nov 20, 2020 9:44 am
by PhantamaroK
geneb wrote: ↑Fri Nov 20, 2020 8:36 am
Try the files in the attached zip. There are profiles for a number of materials & machines.
jwcproductions FFF.zip
g.
Thank you so much for these files! They're very valuable.
Quick question: are the settings in the Rostock MAX v3 profile the same for the v3.2 upgrade?
Re: Simplify3D Settings
Posted: Sat Nov 21, 2020 9:40 am
by geneb
No, the v3 uses an 8 bit RAMBo controller and the v3.2 uses the 32 bit Duet controller. It makes them VASTLY different machines because of that.
g.