how do i remove the filament tube from the hot end device... when ibuilt it i excitedly just put thetube in, never routed it properly in the wire control 'sleeve'.
what do i do to remove it properly fromn the hot end, and the ez-struder? it seems like it there for good!
quick question - how do i take out the bowden tube?
quick question - how do i take out the bowden tube?
------------------------
Magic Marc
ARTEMIS & H2
Magic Marc
ARTEMIS & H2
-
- Printmaster!
- Posts: 616
- Joined: Wed Mar 18, 2015 1:11 am
Re: quick question - how do i take out the bowden tube?
I think the HE280 is the same as the hot end for the old V2 in this respect...The black ring in the center of the top of the hot end is a PTC (push-to-connect) connector. Push it down (towards the nozzle) to release the Bowden tube (in theory). If that doesn't work easily something more creative may be required.
Re: quick question - how do i take out the bowden tube?
that worked, thanks!
------------------------
Magic Marc
ARTEMIS & H2
Magic Marc
ARTEMIS & H2