quick question - how do i take out the bowden tube?

An affordable delta DIY kit made with high quality electronics/parts/hardware
Post Reply
magicmarc
Printmaster!
Posts: 73
Joined: Sun Mar 19, 2017 12:55 am

quick question - how do i take out the bowden tube?

Post by magicmarc »

how do i remove the filament tube from the hot end device... when ibuilt it i excitedly just put thetube in, never routed it properly in the wire control 'sleeve'.

what do i do to remove it properly fromn the hot end, and the ez-struder? it seems like it there for good!
------------------------
Magic Marc
ARTEMIS & H2
IMBoring25
Printmaster!
Posts: 616
Joined: Wed Mar 18, 2015 1:11 am

Re: quick question - how do i take out the bowden tube?

Post by IMBoring25 »

I think the HE280 is the same as the hot end for the old V2 in this respect...The black ring in the center of the top of the hot end is a PTC (push-to-connect) connector. Push it down (towards the nozzle) to release the Bowden tube (in theory). If that doesn't work easily something more creative may be required.
magicmarc
Printmaster!
Posts: 73
Joined: Sun Mar 19, 2017 12:55 am

Re: quick question - how do i take out the bowden tube?

Post by magicmarc »

that worked, thanks!
------------------------
Magic Marc
ARTEMIS & H2
Post Reply

Return to “Hacker Series - H2”