hi, when i printed this part in PLA, it printed pretty well.
then i changed to my artermis se300 petg profile, and tried printing same part, and im getting alot of flashy-ness in areas... not sure how to resolve.
in my picture attachment, the green one was the petg print.
thanks
PETG printing errors
-
- ULTIMATE 3D JEDI
- Posts: 1561
- Joined: Wed Sep 23, 2015 2:55 pm
Re: PETG printing errors
It looks like you're not getting sufficient cooling for it to stay together, and is thus picking plastic back up, then redepositing it elsewhere as zits, or the PETG is too hot and dribbling out uncontrolled
Machines:
Rostock Max V2, Duet .8.5, PT100 enabled E3D V6 and volcano, Raymond style enclosure
Automation Technology 60W laser cutter/engraver
1m X-carve router
Sic Transit Gloria Mundi
01-10011-11111100001
Rostock Max V2, Duet .8.5, PT100 enabled E3D V6 and volcano, Raymond style enclosure
Automation Technology 60W laser cutter/engraver
1m X-carve router
Sic Transit Gloria Mundi
01-10011-11111100001
Re: PETG printing errors
ok, so ill try to lower the hot end temperature... in cura, where would i go to change the cooling settings.. if possible ..
thanks for the assistance..
thanks for the assistance..
------------------------
Magic Marc
ARTEMIS & H2
Magic Marc
ARTEMIS & H2