XY dimensions are incorrect

The one, the only, the Atremis. Forum for the monster metal machine from SeeMeCNC
Post Reply
User avatar
felich
Prints-a-lot
Posts: 22
Joined: Fri Oct 21, 2016 3:41 pm
Contact:

XY dimensions are incorrect

Post by felich »

Is there a way to calibrate the XY dimensions?
Cura shows the correct dimensions but the print comes out shorter in both x and y directions.
Any ideas?
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: XY dimensions are incorrect

Post by geneb »

Shorter by how much?

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
dc42
Printmaster!
Posts: 454
Joined: Mon Mar 07, 2016 10:17 am

Re: XY dimensions are incorrect

Post by dc42 »

If the scaling is consistent, you can use a M579 command in config.g to correct for small scaling errors. To check the scaling is consistent, print a large noughts-and-crosses/tic-tak-toe pattern on the bed, and check that the lines are straight.
Post Reply

Return to “Artemis”