Silicone hot end sock?

This is where you can discuss the RostockMAX v4!
Post Reply
GeckoDeLimon
Noob
Posts: 1
Joined: Fri Mar 22, 2019 9:19 pm

Silicone hot end sock?

Post by GeckoDeLimon »

I've been trying to print more with PETG, and while I've got the stringing under control on my prints themselves, my nozzle & heater block are slowly being covered in black schmoo from the little whisps of PETG. It's also proving harder to remove than PLA deposits.

Will an E3D sock fit? I'd hate to be wrong and use something that "sorta fit". I can only imagine the mess.
DeepsReddy
Plasticator
Posts: 13
Joined: Mon May 13, 2019 10:41 pm

Re: Silicone hot end sock?

Post by DeepsReddy »

Hoping to revive this.
Does anyone know which type of silicone sock would be the closest fit for a se300 hotend on an Artemis?
Trying to avoid ordering a bunch of different ones and cutting them all up.
Thanks
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Silicone hot end sock?

Post by geneb »

It's probably pretty close in size to the E3D heat block - I'd measure it and check.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “RostockMAX v4”