Slic3r 0.7.2b Profiles to get you started

[seemeadmin]

Here's some Slic3r profiles to get you going. Keep in mind that I'm no expert...

I usually keep my Slic3r profiles with my STL models, naming them similar to what I'm printing. And even making a nozzle note or filament note.


Good general straight wall:

bushing block_1750fila_050noz.ini

bushing or 90 bar clamp - fairly solid

(1.49 KiB) Downloaded 403 times

Fair Solid:

spool_hub_175mm_Filament_020_nozzle.ini

spool hub settings

(1.49 KiB) Downloaded 337 times

Creature Feature (like yoda):

yoda_1750mm_Filament_020inch_050mm_nozzle.ini

creature settings for Slic3r

(1.49 KiB) Downloaded 389 times

~PartDaddy~

[jbinion]

I was reading your .ini files and it says bed is 200x200. Are you using the full area available for the bed? and is the size metric?
Thanks,
jim

[johnoly99]

Jim, john here. Steve must have left that as the default. I usually have it set to 185*185, and yes that is in mm