Welcome to the SeeMeCNC Community

Does anyone happen to have a copy of this? The link provided on their website has been down for a couple days, so I'm a bit unfamiliar with some of the terminology used.

Right now I'm using the settings provided by MHackney, and I'm already getting better prints than I ever got off the default Rostock slicer (big thanks for those!). I'm hoping to get my extrusion diameter dialed in properly, but I don't completely understand what all the changes will do.

You can get it here: http://2015.3ntr.eu/wp-content/uploads/ ... ual_en.pdf" onclick="window.open(this.href);return false;

I just downloaded it.

Also, do you know about the http://www.kisslicertalk.com/" onclick="window.open(this.href);return false; forum? I tracked this down through there.

Yes. That is where I was trying to get it. It worked just now. I think a firewall at work may have been blocking it. I get that with random sites.

That forum seemed much less active than this one, so I asked here.

Thanks

Thanks for the link to the Kisslicer manual, Michael.