New GA Member
Posted: Mon Nov 28, 2016 11:59 pm
Hello,
Checking in from the Atlanta suburbs and wanted to share my experience.
Finished up my Rostock Max V3 and have to say that I am very impressed. All my previous 3d printing experiences have all been with a Wanhoa i3. It was great to learn on, but I really wanted to build something so I could fully understand it. I was nervous spending this much on a box of parts, but I now feel like it was well worth it. The technical support during the build was top notch and the overall experience reinforced the value proposition. Knowing there are replacement parts and having the confidence to dive right in just piles on the comfort in my decision.
Checking in from the Atlanta suburbs and wanted to share my experience.
Finished up my Rostock Max V3 and have to say that I am very impressed. All my previous 3d printing experiences have all been with a Wanhoa i3. It was great to learn on, but I really wanted to build something so I could fully understand it. I was nervous spending this much on a box of parts, but I now feel like it was well worth it. The technical support during the build was top notch and the overall experience reinforced the value proposition. Knowing there are replacement parts and having the confidence to dive right in just piles on the comfort in my decision.
