Rostock v3 vs Rostock v3.2

Introduce yourself to the community!
Post Reply
Dexter Carhart
Plasticator
Posts: 8
Joined: Thu Jul 22, 2021 11:53 am

Rostock v3 vs Rostock v3.2

Post by Dexter Carhart »

Hello. I am trying to start printing on my Rostock v3. I went to the quick start guide and the only instructions that I could find were for the Rostock v3.2. I was told that they were the same but when I started looking at the instructions they were not consistent with my printer. I seem to have an older version. which brings me to the question if there is a difference between the two? If so, could someone please send me the proper configuration instructions for the Rostock v3? it would be much appreciated as I have looked everywhere. Thank you.
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Rostock v3 vs Rostock v3.2

Post by geneb »

They're nearly identical mechanically, but vastly different electronically.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Rostock v3 vs Rostock v3.2

Post by geneb »

All of the Rostock MAX v3 manuals can be found here: https://www.seemecnc.com/pages/downloads - scroll down down to "Rostock MAX v3".

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “New Member introduction”