I need help

Introduce yourself to the community!
Post Reply
Dexter Carhart
Plasticator
Posts: 8
Joined: Thu Jul 22, 2021 11:53 am

I need help

Post by Dexter Carhart »

Hello everyone. I own an Artemis 300. About a month ago I began to have issues with my hotend. It then stopped working altogether. I was told by someone that it was most likely an issue with the duet board. I proceeded to order a new one and I disconnected the old one. It was only after doing this that I realized that I am in over my head. I don't know enough about electronics to get the new duet board hooked up. I looked at the layout of the duetboard on the seemecnc website, but there are no indications of what wires go into the named sections. Nor are there any indications on the wires. I am wondering if I am able to send my Artemis back to seemecnc for maintenance, or if there is anywhere else that I can send it to get fixed. Please let me know. I need help and I am not able to figure it out on my own.
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: I need help

Post by geneb »

I would email support.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “New Member introduction”