3 axis board dip switches

Post Reply
@CiDG
Prints-a-lot
Posts: 22
Joined: Mon Mar 26, 2012 9:08 pm

3 axis board dip switches

Post by @CiDG »

Hello and thanks for your time! I have an H1 complete kit and I'm not sure about the DIP switches on the 3 axis board. What is the proper configuration for these? As it arrived, I have a loud and weak Z axis (will not move and makes tons of noise as if fighting itself) when commanded to move. I was having an issue with my parallel port on the first computer I tried to use for this printer and all axis motors were buzzing loudly and the extruder motor was dead. After changing desktops, I found this issue and it led me to wonder about the dips.
Help is appreciated! Thanx again!
Gabe
User avatar
mhackney
ULTIMATE 3D JEDI
Posts: 5412
Joined: Mon Mar 26, 2012 4:15 pm
Location: MA, USA
Contact:

Re: 3 axis board dip switches

Post by mhackney »

Please pm me yr email address so I can send you the draft of the electronics manual, it has all of this stuff in it for the stock configuration like you are looking for!

Regards,
Michael

Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art

Start Here:
A Strategy for Successful (and Great) Prints

Strategies for Resolving Print Artifacts

The Eclectic Angler
User avatar
Chris Muncy
Printmaster!
Posts: 137
Joined: Mon Mar 26, 2012 1:30 pm
Location: Willis, Texas

Re: 3 axis board dip switches

Post by Chris Muncy »

Here's the dip switch settings commonly used:
(it would sure help if I uploaded the correct file..)
Attachments
Dip Switch Settings
Dip Switch Settings
Chris Muncy
H-1 #5
Post Reply

Return to “Parallel Port based boards”