Hi all,
I hope that this is in the right section.
I have a SeeMeCNC Orion and two Ultimakers. I am wondering if anyone has created a separate profile for their Orion using Cura? I'd like to consolidate my operation to one slicing program, if possible. Has anyone used Cura with their Orion, and are you willing to share with me the specs?
Thanks,
Andrea
Using Cura with SeeMeCNC Orion
Re: Using Cura with SeeMeCNC Orion
Oh, woah...
I think that I resolved my own problem: https://seemecnc.dozuki.com/Guide/Setti ... 87?lang=en
I'll set it up, and once I reassemble my printer, I'll give it a go.
I think that I resolved my own problem: https://seemecnc.dozuki.com/Guide/Setti ... 87?lang=en
I'll set it up, and once I reassemble my printer, I'll give it a go.