Page 1 of 1
My video on basic e-steps calibration
Posted: Sun Sep 28, 2014 6:10 am
by McSlappy
I'd been asked to do a video covering e-steps calibration so here it is!
It doesn't go very deep, but hopefully enough information to take the mystery out of it
Let me know what you think.
Re: My video on basic e-steps calibration
Posted: Sun Sep 28, 2014 8:46 am
by crocky
I don't see a link?
Still waiting for a set of crimping pliers from China...
Re: My video on basic e-steps calibration
Posted: Sun Sep 28, 2014 9:54 am
by lightninjay
[youtube]
http://www.youtube.com/watch?v=1GyiivRWzHc[/youtube]
I got your back McSlappy!
Re: My video on basic e-steps calibration
Posted: Sun Sep 28, 2014 3:07 pm
by Generic Default
I need to do this for my extruder! I'm still using Steve's extruder and when I switched to the smoothieboard, my E-steps somehow got messed up. I don't have it perfect but I found out that under-extruding is much better than over-extruding.
Re: My video on basic e-steps calibration
Posted: Sun Sep 28, 2014 6:09 pm
by McSlappy
Oh man.... what would I do without people like you who have their wits together... Thanks!
Re: My video on basic e-steps calibration
Posted: Mon Aug 17, 2015 10:17 am
by dajay23D
thanks for the videos McSlappy! I love your videos. You need to make more! Maybe some longer ones, since I like them so much. I find it very informative and funny.
Re: My video on basic e-steps calibration
Posted: Thu Feb 25, 2016 3:33 pm
by Eaglezsoar
Good job on the video! We can read about it but there is nothing like seeing how it is done.