BossDelta300 heater fail

Having a problem? Post it here and someone will be along shortly to help
Post Reply
geofbuck
Noob
Posts: 1
Joined: Tue Jan 03, 2023 11:08 am

BossDelta300 heater fail

Post by geofbuck »

Does anyone know where the fuse is for the heater? I was told there was a 5A fuse on the duet control board but I opened up the base of the printer and I don't see one. There is only a blue automotive 15A fuse. Where else could it be located? My brand new unit won't even print. It fails when trying to heat before printing even starts.
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: BossDelta300 heater fail

Post by geneb »

The fuse locations can be found here:
https://docs.duet3d.com/Duet3D_hardware ... e_Overview

look at the "features" section - the fuses are shown with a red highlight and they're on the right side of the board.

I would also check to make sure that the connectors on the SE300 haven't come un-seated - even a little bit could cause an issue.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “Troubleshooting”