Hi all,
I am just getting my H1 running but it won't move, wiring wrong?
One of those 4-axis boards.
Using Mach config from this forum, posted by mhackney
motor wiring as shown on drawing from SeeMeCNC for 3-axis;
---green
---black
---blue
---red
board switches;
1-off
2-on
3-on
4-on
5-off
6-off
Also, what temperature should I start with?
And what pins should I jumper when I remove opto isolaters?
Thanks!
~*Brian VanDiepenbos
Goshen, IN
New machine configuration wtk 4-axis board
- bvandiepenbos
- Printmaster!
- Posts: 927
- Joined: Thu Apr 05, 2012 11:25 pm
- Location: Goshen, IN
- Contact:
New machine configuration wtk 4-axis board
~*Brian V.
RostockMAX v2 (Stock)
MAX METAL "ShortyMAX"
MAX METAL Rostock MAX Printer Frame
NEMESIS Air Delta v1 & v2 -Aluminum delta printers
Rostock MAX "KITT" - Tri-Force Frame
GRABER i3 "Slim"
RostockMAX v2 (Stock)
MAX METAL "ShortyMAX"
MAX METAL Rostock MAX Printer Frame
NEMESIS Air Delta v1 & v2 -Aluminum delta printers
Rostock MAX "KITT" - Tri-Force Frame
GRABER i3 "Slim"
Re: New machine configuration wtk 4-axis board
Brian, start with basics,
when you power on and enable mach (the big RED estop button at the lower left on the screen) do you hear and feel the steppers energize?
If not, then we need to get that sorted. I am now using the 4 axis board so I can send some photos later.
As for temp, that is controlled manually by the velleman thermostat. Lets leave that unplugged (disconnected) until we get your axis moving!
cheers,
Michael
when you power on and enable mach (the big RED estop button at the lower left on the screen) do you hear and feel the steppers energize?
If not, then we need to get that sorted. I am now using the 4 axis board so I can send some photos later.
As for temp, that is controlled manually by the velleman thermostat. Lets leave that unplugged (disconnected) until we get your axis moving!
cheers,
Michael
Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art
Start Here:
A Strategy for Successful (and Great) Prints
Strategies for Resolving Print Artifacts
The Eclectic Angler
Re: New machine configuration wtk 4-axis board
Just left Brians house (hes literally 2 miles from our shop!) And he now is the oriud papa of a running, printing "little squirt"
Re: New machine configuration wtk 4-axis board
Great! What was the problem? It might help others to know.
cheers,
Michael
cheers,
Michael
Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art
Start Here:
A Strategy for Successful (and Great) Prints
Strategies for Resolving Print Artifacts
The Eclectic Angler
-
- Plasticator
- Posts: 11
- Joined: Tue Sep 10, 2013 3:30 am
Re: New machine configuration wtk 4-axis board
great i have the same problem what did you do can you come to my house and fix it too???????????????????