Just ran a part (lounge chair coaster) I created in FreeCad and G-code created with Slic3r. The surface with the "C" is flat, yet it printed very rough with oddball "tracks". Would I be better off trying Cura, or different settings? .2 layers, 3 solid Top/bottom layers, 25% infill honeycomb concentric. Suggestions?
PS: Don't order Hatchbox dark brown if you don't want dark purple! Exchanging this roll for black.
Top Layer
-
- Printmaster!
- Posts: 622
- Joined: Wed Apr 13, 2016 7:42 pm
Re: Top Layer
It kind of looks like you are overextruding a little bit.