Rostock Max V2 printing issues
Posted: Sun May 17, 2020 7:38 pm
Hi all, have a Rostock Max V2 with ballcup arm and carriage upgrade. Have been dealing with a printing issue that causes the wall and infill not to connect.Have already calibrated level and H. radius as well as stiffening of the hot end/platform. Have also tried changing the arm length in the EEPROM to both 90.8 and 91.06 but still dont have a fix.
thank for your time.
below is a link to picture of the rough print quality and separation of infill and walls.
https://drive.google.com/open?id=1QIpm9 ... Jg2EIAa9Iy
thank for your time.
below is a link to picture of the rough print quality and separation of infill and walls.
https://drive.google.com/open?id=1QIpm9 ... Jg2EIAa9Iy