Trouble configuring Artemis 300 (December 2021)

Having a problem? Post it here and someone will be along shortly to help
Post Reply
Dexter Carhart
Plasticator
Posts: 8
Joined: Thu Jul 22, 2021 11:53 am

Trouble configuring Artemis 300 (December 2021)

Post by Dexter Carhart »

I had an issue with my hot end and sent it to SeeMeCNC for maintenance. It was just delivered back to me. I Believe they updated the firmware. I am trying to connect it to wifi but when I enter the following commands as it states to do in the guide (M552 S0, M587 S"NetWorkSSID" P"password", M552 S1) the response I am getting from the printer is "Wifi reported error: no known networks found." does anyone have any suggestions? Is there a new way to connect the Artemis to wifi that I am not aware of? let me know. Thanks.
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Trouble configuring Artemis 300 (December 2021)

Post by geneb »

If you've got a WiFi network with both 2.4Ghz and 5Ghz radios AND use the same SSID for both, it could cause that issue.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “Troubleshooting”