Mcbride's build

[mcbride19]

As I promised here is my build log
My wife bought it for my birthday ...
Since everything went fine I will just show you different step of the build and the result, it will be more clear

So here is the photos:
the beginning(Ouch it smell like burned wood someone made a barbecue ? ):

[img]http://imageshack.us/a/img208/6541/khqz.jpg[/img]

then

[img]http://imageshack.us/a/img15/5183/cizx.jpg[/img]

step 3
[img]http://imageshack.us/a/img203/1143/a7z7.jpg[/img]

next

[img]http://imageshack.us/a/img30/4893/po4.JPG[/img]

A better way to put the belts inside the holes, roll it in your fingers, the belt will stay round , now you can pass it trough the holes !
[img]http://imageshack.us/a/img199/5308/9zxf.JPG[/img]
[img]http://imageshack.us/a/img819/7906/btz4.jpg[/img]

step 5

[img]http://imageshack.us/a/img15/3971/ieiu.jpg[/img]

the final

[img]http://imageshack.us/a/img15/1818/a0dz.jpg[/img]

The fist print. yes I know it wasn't the hollow cube I decided to print a useful think to prevent clogging(filament dust remover)
[img]http://imageshack.us/a/img32/2332/114.JPG[/img]
[img]http://imageshack.us/a/img94/9307/owiz.jpg[/img]

then the Hollow cube test

[img]http://imageshack.us/a/img28/4690/17zu.jpg[/img]


So everything went fine , it took me 4 days to build it with the collaboration of my wife.
It works far better than my solidoodle 2 and the quality is also better

[Eaglezsoar]

Looks Great! That is one of the best first prints I have seen on the Forum. Your settings must be awfully close
to what they should be. Good job!

[mcbride19]

Thanks !

For the settings I have some experiences with the Solidoodle 2 , I think it's not very hard to find best settings if you take time to understand how it works ans also to take a look on what have been done by other users.
I must admit that I'm really proud of my hollow cube, the bridges are quite perfect and i've also been surprised when I saw this result.