Silicone Bed/SSR Gradual Temp Drop
Posted: Sat Jun 02, 2018 6:09 pm
Any idea what would be causing the bed temp to drop during printing?
The drop seems to start when it begins printing and gradually declines a .10 of a degree at a time.
My wiring seems to be ok, otherwise I assume it wouldn't reach target temperature.
Since the bed is powered by a separate line source I assume it's not from a lack of power from the rambo board.
Thanks anybody.
The drop seems to start when it begins printing and gradually declines a .10 of a degree at a time.
My wiring seems to be ok, otherwise I assume it wouldn't reach target temperature.
Since the bed is powered by a separate line source I assume it's not from a lack of power from the rambo board.
Thanks anybody.