I R DONE!!!!!1

All about the retired, first generation H-1 3D printers
Post Reply
jbinion
Printmaster!
Posts: 84
Joined: Mon Jun 04, 2012 11:46 am

I R DONE!!!!!1

Post by jbinion »

Well not really but petty close. Still need to wire up the controller and pretty much every thing else. I have two LED thermostats from ebay. One for the heated bed, the other I hope to be able to use the thermocoupler and the led readout to measure the temp on the hot end. The first picture is of the plexiglas box we made for the electronics and the two blue cooling fans.
Ellen's box and blue cooling fans
Ellen's box and blue cooling fans
Front view.
Front view.
View from the top
View from the top
Position LED and Velleman Thermostat
Position LED and Velleman Thermostat
jbinion
Printmaster!
Posts: 84
Joined: Mon Jun 04, 2012 11:46 am

Re: I R DONE!!!!!1

Post by jbinion »

We put the box together so we can take the printer off and use the controller system for a CNC if we wanted to.
tom10122
Printmaster!
Posts: 401
Joined: Fri May 11, 2012 11:18 pm
Location: NJ

Re: I R DONE!!!!!1

Post by tom10122 »

Nice enclosure , Is there a way for the air to circulate though?
jbinion
Printmaster!
Posts: 84
Joined: Mon Jun 04, 2012 11:46 am

Re: I R DONE!!!!!1

Post by jbinion »

We have a large fan on the top pulling air out to the bottom of the table and one in the front to push air into the enclosure. So far it seems to be keeping everything cool.
tom10122
Printmaster!
Posts: 401
Joined: Fri May 11, 2012 11:18 pm
Location: NJ

Re: I R DONE!!!!!1

Post by tom10122 »

Ok Just wondering
Post Reply

Return to “H-1 3D Printers”