Cura 15.04.6 turns off hot end before print

Talk about Cura software here (http://wiki.ultimaker.com/Cura)
Post Reply
rhoded
Prints-a-lot
Posts: 34
Joined: Mon Oct 05, 2015 2:58 pm

Cura 15.04.6 turns off hot end before print

Post by rhoded »

I copied as many as the relevant settings from http://forum.seemecnc.com/viewtopic.php?t=7729 as I could for Cura on both my Mac and Linux machine. Then I tried to print and the hot end and bed would reach temperature but as soon as the movements start, the hot end and bed are set to 0°. Does anyone know what I should change to get it to work?
Post Reply

Return to “Cura”