CuraEngine in Repetier Host

Talk about Cura software here (http://wiki.ultimaker.com/Cura)
Post Reply
ericpudding
Printmaster!
Posts: 40
Joined: Fri Sep 05, 2014 2:44 pm

CuraEngine in Repetier Host

Post by ericpudding »

Is there any difference in using the CuraEngine slicer that's already one of the slicers in Repetier Host rather than the standalone Cura software? Can you actually set up the standalone Cura to work with a Rostock Max V2 or is it only used to make the G code?
User avatar
Tincho85
Printmaster!
Posts: 659
Joined: Sun Nov 03, 2013 12:27 pm
Location: Buenos Aires, Argentina

Re: CuraEngine in Repetier Host

Post by Tincho85 »

I really don't know, I've always used CuraEngine and it works fine. Never found the need to install the stand alone program.
If nobody else answers here, you could compare both G-codes and see if there is a difference.
Martín S.
Post Reply

Return to “Cura”