My Rostock MAX v3 kit
-
- Noob
- Posts: 2
- Joined: Wed Jan 25, 2017 10:48 pm
My Rostock MAX v3 kit
Complete newbie to 3d printing and had my v3 built in about 20 hours of build time. The best advice I can give is make sure you have a good soldering gun/pen. I upgraded mine about a third of the way through the build and it made a huge difference. I only had one minor issue during initial calibration where a stepper motor need a bit more tension, but it was easy to tell what the issue was. After that adjustment everything worked as designed. Great job on the kit SeeMeCNC.