Welcome to the SeeMeCNC Community

Hi everybody,

I finished building my printer last september. After somes upgrade and learning I decided to take some pictures for you guys.
I installed an homemade heat spreader under the glassplate and a PEI sheet o the glass. I upgrade the hotend for a PrometheusV2 and I build an enclosure for my crazy white ABS. Have changed my stock cheapskate carriage with my own SLS set, because my two sets have broken where the screws are...

My Rostock MAX V2
[img]http://img4.hostingpics.net/thumbs/mini_749389IMG3542.jpg[/img]

Printing ABS White, cannot have parts without curling with this one.
[img]http://img4.hostingpics.net/thumbs/mini_735617IMG3539.jpg[/img]

SLS carriage
[img]http://img4.hostingpics.net/thumbs/mini_703917IMG3545.jpg[/img]

[img]http://img4.hostingpics.net/thumbs/mini_204192IMG3546.jpg[/img]