just testing a bit.
ABS with too low a temperature at the hotend, 215 was not enough... 230 and it is fine!
ABS Failed
ABS Failed
Bob
Rostock Max V2, Ball Cup Arms, New Carriages, HE280, Dampers, PSU Breathing, Simplify 3D, GeckoTek3D, Raspberry Pi3. Duet soon... Kossel Mini still under construction.
Delta's are the way!
Rostock Max V2, Ball Cup Arms, New Carriages, HE280, Dampers, PSU Breathing, Simplify 3D, GeckoTek3D, Raspberry Pi3. Duet soon... Kossel Mini still under construction.
Delta's are the way!
- Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: ABS Failed
Isn't it fun to come up with correct printing temperatures, alignment problems, etc.
We have to love our Rostocks!
We have to love our Rostocks!
Re: ABS Failed
HA HA HAAA
I have the same print, in the same color, failed in a similar manner. But I got about 1 cm higher than you
But Basturgach prevailed in the end.
I have the same print, in the same color, failed in a similar manner. But I got about 1 cm higher than you
But Basturgach prevailed in the end.
When on mobile I am brief and may be perceived as an arsl.
- Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: ABS Failed
Hey Teoman, those vases look really good!
Re: ABS Failed
That's the one, I was trying the pink one
They look terrific.....
They look terrific.....
Bob
Rostock Max V2, Ball Cup Arms, New Carriages, HE280, Dampers, PSU Breathing, Simplify 3D, GeckoTek3D, Raspberry Pi3. Duet soon... Kossel Mini still under construction.
Delta's are the way!
Rostock Max V2, Ball Cup Arms, New Carriages, HE280, Dampers, PSU Breathing, Simplify 3D, GeckoTek3D, Raspberry Pi3. Duet soon... Kossel Mini still under construction.
Delta's are the way!