Octoprint disconnecting in consistently with certain prints
Posted: Sun Feb 15, 2015 2:19 pm
I've got a Rostock Max V2, and i've had octoprint set up for a couple weeks now without issue.
Now suddenly, about every other model/gcode file, octoprint will disconnect and stop my print at the exact same place in the print, usually at the beginning, but always in the same place no matter how many times I restart the print. If I connect my Max to my computer and print the same Gcode through repeiter host, it prints fine. If I load up a different model/gcode file to octoprint, it will print it fine. Then after, I'll load a new gcode file, and it disconnects again. What could I try to go about troubleshooting this?
Much appreciated!!!
Now suddenly, about every other model/gcode file, octoprint will disconnect and stop my print at the exact same place in the print, usually at the beginning, but always in the same place no matter how many times I restart the print. If I connect my Max to my computer and print the same Gcode through repeiter host, it prints fine. If I load up a different model/gcode file to octoprint, it will print it fine. Then after, I'll load a new gcode file, and it disconnects again. What could I try to go about troubleshooting this?
Much appreciated!!!