Upgraded V2 automagic calibration question.
- barry99705
- Printmaster!
- Posts: 707
- Joined: Sun Aug 11, 2013 6:10 pm
- Location: west ohio
Upgraded V2 automagic calibration question.
Hey guys, I have one of those fancy pants boards on the hot end so it does the tappity-tap-tap auto calibration. When it's doing this, shouldn't the effector platform stay parallel to the bed?
Never do anything you don't want to have to explain to the paramedics.
Re: Upgraded V2 automagic calibration question.
Which one do you have, the HE280 or the SE300? (what controller is in the printer?)
The effector should always be parallel with the build plate.
g.
The effector should always be parallel with the build plate.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
- barry99705
- Printmaster!
- Posts: 707
- Joined: Sun Aug 11, 2013 6:10 pm
- Location: west ohio
Re: Upgraded V2 automagic calibration question.
The HE280. Controller is the standard Rambo, not sure which version. Now that I've watched it a few times, I think it's the flying extruder I added. Pulling too much on the hot end.
Never do anything you don't want to have to explain to the paramedics.
- barry99705
- Printmaster!
- Posts: 707
- Joined: Sun Aug 11, 2013 6:10 pm
- Location: west ohio
Re: Upgraded V2 automagic calibration question.
Nope, that wasn't it. Now when I hit calibrate, the board resets. Any ideas? Firmware is 92.2
Never do anything you don't want to have to explain to the paramedics.
- barry99705
- Printmaster!
- Posts: 707
- Joined: Sun Aug 11, 2013 6:10 pm
- Location: west ohio
Re: Upgraded V2 automagic calibration question.
Holy crap. SD card corrupted. Put a new on in, and it was formatted fat32, didn't realize that. Reformatted fat, calibration runs now. Effector platform still not running level at the tap points though.
[img]https://lh3.googleusercontent.com/BhXTL ... 24-h768-no[/img]
[img]https://lh3.googleusercontent.com/BhXTL ... 24-h768-no[/img]
Never do anything you don't want to have to explain to the paramedics.
Re: Upgraded V2 automagic calibration question.
The image doesn't show up.
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects