Ninjaflex dampers?
-
- Printmaster!
- Posts: 809
- Joined: Wed Dec 11, 2013 9:11 pm
- Location: Queensland, Australia
- Contact:
Ninjaflex dampers?
Would it be possible to print a thin (2mm thick) plate from Ninjaflex which sits between the Nema 17 stepper motors and the frame? Would this dampen the vibrations at all? Any ninjaflex users able to test?
I loved my Rostock so much I now sell them in Oz
Re: Ninjaflex dampers?
good call, ill wait for someone else to do it... i don't feel like tearing my steppers apartMcSlappy wrote:Would it be possible to print a thin (2mm thick) plate from Ninjaflex which sits between the Nema 17 stepper motors and the frame? Would this dampen the vibrations at all? Any ninjaflex users able to test?
-
- Printmaster!
- Posts: 809
- Joined: Wed Dec 11, 2013 9:11 pm
- Location: Queensland, Australia
- Contact:
Re: Ninjaflex dampers?
Yeah... Even if I had them, I'd proably put it off for a while - I don't feel like pulling my machine apart just yet
I loved my Rostock so much I now sell them in Oz