DIY curing oven...
Posted: Sun Jun 26, 2016 11:31 am
I've been doing some research in order to get all the data I need in order to get the DropLit v2 user manual written. One of the last things on my list was something to do the "final" cure on the part after it had been printed. A friend turned me on to this: http://forum.formlabs.com/t/budget-uv-cure-box-jar/3176.
Here's my version:
[img]http://www.geneb.org/duet/curing-oven-1.png[/img]
[img]http://www.geneb.org/duet/curing-oven-2.png[/img]
[img]http://www.geneb.org/duet/curing-oven-3.png[/img]
You fill it with water and leave the printed part in it for 30 minutes or so. The water prevents oxygen from slowing down the curing process that the UV is doing.
g.
Here's my version:
[img]http://www.geneb.org/duet/curing-oven-1.png[/img]
[img]http://www.geneb.org/duet/curing-oven-2.png[/img]
[img]http://www.geneb.org/duet/curing-oven-3.png[/img]
You fill it with water and leave the printed part in it for 30 minutes or so. The water prevents oxygen from slowing down the curing process that the UV is doing.
g.