firmware and cw correct setting needed

Vat designs and coatings etc..., Electronics and mods, Z stages and mechanisms to release the prints from Vats etc...
Post Reply
michaels
Plasticator
Posts: 8
Joined: Sun Mar 03, 2013 11:54 pm
Location: Connecticut

firmware and cw correct setting needed

Post by michaels »

I had my company buy the droplit printer. It sat on a shelf for over one year before I was asked to help them out. I have the printer together and projector all set.
I am unable to find the firmware needed and with CW I am unable to locate setting.

Any help would be great.

mike
User avatar
KAS
ULTIMATE 3D JEDI
Posts: 1157
Joined: Thu Dec 04, 2014 6:06 pm

Re: firmware and cw correct setting needed

Post by KAS »

See if this will help you: https://github.com/seemecnc
User avatar
Jimustanguitar
ULTIMATE 3D JEDI
Posts: 2631
Joined: Sun Mar 31, 2013 1:35 am
Location: Notre Dame area
Contact:

Re: firmware and cw correct setting needed

Post by Jimustanguitar »

You might want to give JJ and the support team a shout. I'm not sure what their "stock" program is now. Creation Workshop went closed source last year, so the documentation and support for it are non existent now. I still use an old version of it, as do many others, but I've got a different machine with a simpler Arduino setup. I think the DropLit uses a Rambo mini, right?

All the cool kids are switching to Raspberry Pi control with a program called NanoDLP. http://www.nanodlp.com/
michaels
Plasticator
Posts: 8
Joined: Sun Mar 03, 2013 11:54 pm
Location: Connecticut

Re: firmware and cw correct setting needed

Post by michaels »

Thanks will look on github
Post Reply

Return to “DropLit”