Welcome to the SeeMeCNC Community

I had my company buy the droplit printer. It sat on a shelf for over one year before I was asked to help them out. I have the printer together and projector all set.
I am unable to find the firmware needed and with CW I am unable to locate setting.

Any help would be great.

mike

See if this will help you: https://github.com/seemecnc

You might want to give JJ and the support team a shout. I'm not sure what their "stock" program is now. Creation Workshop went closed source last year, so the documentation and support for it are non existent now. I still use an old version of it, as do many others, but I've got a different machine with a simpler Arduino setup. I think the DropLit uses a Rambo mini, right?

All the cool kids are switching to Raspberry Pi control with a program called NanoDLP. http://www.nanodlp.com/

Thanks will look on github