Curing Large Parts by Changing Device Geometry

A place to talk about ideas for other tech around resin 3d printing
Post Reply
User avatar
JohnStack
Printmaster!
Posts: 852
Joined: Thu Jan 03, 2013 7:07 pm
Location: Carlsbad, CA
Contact:

Curing Large Parts by Changing Device Geometry

Post by JohnStack »

Over the weekend, I was thinking that larger parts could be cured by changing to larger petrie dishes, substrate location (bed), and projection dimensions.

It's my guess that higher resolution (1080i/p) projectors would have to be used - which then led me to trying to figure out the differences in DLP chipsets. TI and Mitsubishi make some of the chips. Looking at IT, there's a 055 DLP, 065 DLP and something called a 1080p DLP DarkChip technology - supporting home theatre.



On a separate note, I found this little jewel that very nicely explains DLP and printing. The interesting thing that I saw was the "inkjet" parts. Hmmm...so if Z went in reverse and there was a curing vat that supported that...next model John?

http://www.ti.com/solution/dlp_3d_printer#Tools" onclick="window.open(this.href);return false; and Software

And a decent high level on DMD for projectors.

http://www.globalprojectors.com/The-imp ... _58-1.html" onclick="window.open(this.href);return false;
Technologist, Maker, Willing to question conventional logic
http://dropc.am/p/KhiI1a" onclick="window.open(this.href);return false;
Post Reply

Return to “Development Ideas”