Raspberry Pi 3 Mount for Eris

The ERIS Delta, a truly affordable entry into Delta 3D Printing
Post Reply
sgraber
Printmaster!
Posts: 40
Joined: Sat Mar 22, 2014 5:40 pm
Contact:

Raspberry Pi 3 Mount for Eris

Post by sgraber »

I thought I'd throw this snap-on bracket out there for the group in case anyone is wanting to run their Eris with OctoPrint:

http://repables.com/r/787/

Mount your Pi to it and snap it on the back tower and you're good-to-go. Photos: https://goo.gl/photos/sGec9TcXQrDWDMfT7

Thank you to Oly for the original mount!
User avatar
626Pilot
ULTIMATE 3D JEDI
Posts: 1720
Joined: Tue May 14, 2013 12:52 pm

Re: Raspberry Pi 3 Mount for Eris

Post by 626Pilot »

That's a really nice design. How are you faring with the autolevel feature?
sgraber
Printmaster!
Posts: 40
Joined: Sat Mar 22, 2014 5:40 pm
Contact:

Re: Raspberry Pi 3 Mount for Eris

Post by sgraber »

Auto-leveling seems to work OK. I tend to run it after every print since I am removing the build platform and it doesn't get put back into the exact same orientation every time. Pretty easy if you are using Mattercontrol or Octoprint.
djkirkendall
Plasticator
Posts: 15
Joined: Sat Dec 31, 2016 5:22 pm

Re: Raspberry Pi 3 Mount for Eris

Post by djkirkendall »

This mount is awesome, thanks for working it up and sharing it.

I wound up stealing power from the "Eris" LED up front. Plenty of Juice to run the pi. I soldered in a parallel line from the circuit board.
Post Reply

Return to “ERIS Delta”