Welcome to the SeeMeCNC Community

Posted: **Fri Sep 16, 2016 4:23 pm**

Hi, I have just started using my Eris. I have a Rostock V2 as well. After my first two prints (the calibration box and a small camera mount for a quadcopter) the Eris z height raised so the PLA barely lays down on the glass. I have run the calibration multiple times but it doesnt seem to help. Should I just increase the z_max in the eprom by .1mm until its better? Or is there another issue/fix?
Thanks!

Posted: **Fri Sep 16, 2016 7:27 pm**

You should be probing with it cold.

Posted: **Sat Sep 17, 2016 9:05 am**

I was.

Posted: **Sun Sep 18, 2016 6:16 pm**

Does anybody have any ideas why this has happened?

Posted: **Sun Sep 18, 2016 6:31 pm**

what slicer and can you post a sample gcode?

Welcome to the SeeMeCNC Community

Issue with z height?

Issue with z height?

Re: Issue with z height?

Re: Issue with z height?

Re: Issue with z height?

Re: Issue with z height?