Hello,
So I built an enclosure for the printers and installed a heat lamp.
I want to control the lamp with SSR, do you know where I buy some SSR's with 12V control and 220V load?
also I would like to assign a new output pin from the rambo to control the SSR is that possible?
thanks a lot.
SSR to control the heatlamp
- Jimustanguitar
- ULTIMATE 3D JEDI
- Posts: 2631
- Joined: Sun Mar 31, 2013 1:35 am
- Location: Notre Dame area
- Contact:
Re: SSR to control the heatlamp
That's a pretty standard SSR, actually. Finding one for DC output is much trickier.
I've used these before. It's a nicer heatsink than most. https://www.inventables.com/technologie ... tate-relay" onclick="window.open(this.href);return false;
I've used these before. It's a nicer heatsink than most. https://www.inventables.com/technologie ... tate-relay" onclick="window.open(this.href);return false;
Re: SSR to control the heatlamp
thanks
I order 5 of the for all my printers.
any info on how to connect it to a free pin on the rambo board?
I order 5 of the for all my printers.
any info on how to connect it to a free pin on the rambo board?