Welcome to the SeeMeCNC Community

Thank you Everyone ! It's Fixed, It turned out to be a bad/ intermittent pin connection on the cable connector for the stepper. It was connected every time I checked it with a meter but would not work when connected to the motor.

Couple of things I forgot to add. This is happening without any filament loaded. I have run a hundred or so successful prints up to this point.

Hello all. I am having issues with my extruder stepper. It was intermittent at first but is now constant. I had thought it was the motor at first but I just replaced it and the new one is doing the same thing. If I am running a print or using manual controls it just grinds/vibrates like it is going ...