Welcome to the SeeMeCNC Community

Wow. Great surface finish.

Do you mind sharing your config settings?

Thanks, Blinky.

I was not modifying the filename to *.gco. Bah. I'm an idiot.

I have upgraded to Poly's .82.2 firmware. The printer does not recognize any of my *.gcode files, but it recognizes my *.stl files; this proves that the soldering/wiring works as intended. I have tried many different naming conventions and slicers. I have not modified the firmware settings in anyway ...

The file is recognized. I can pull it up; the file name will show up. The problem is that it does nothing when I tell it to print when decoupled from the lap top. It sits idle after I command it to print; the LCD will state " PRINTING", but the hot end or bed does not get hot and it doesn't print. I ...

Hi Geneb, Thanks for your reply. After selecting my file under the print command, it does not start to heat the bed or hot end. I have looked at the G-code and it says displays the correct bed and hot end heat-up code. Is my 1 through 4 process correct? Moreover, the display lights up correct and I ...

Hello Everyone, I'd like to thank you for opening my thread. I hope I can later help one of you out! In the mean time, I feel like a dumbass in that I cannot figure out how print from my SD Card. I have printed muliple parts from my Rostock. It prints items just fine. However, I need separate my ...