Welcome to the SeeMeCNC Community

Hello again, I've just disassembled the hot end and discovered the following: The inner teflon liner (thinner one) has a change in diameter in the last 4-5 mm so when the ABS goes in, it moves without difficulty until it gets to this smaller diameter section where it get's stuck. Even with my hands ...

Hello! The temp is pretty stable, fluctuating +-2.5˚ form the 240˚. I've changed the width settings to .55, but my problem is way before all that. It doesn't extrude! Sometimes at all, sometimes very little so I don't get 100 mm when I extrude 100 mm. Between 15 and 40... If I push up the ABS while e ...

Hello,

I'm very sorry.
Here is the link:

https://www.dropbox.com/s/iyle8lzsnm89b ... owCube.jpg

When not even the old copy and paste works...

Octavio

Hello John and Lordbinky.

Thank you for your help.
I've started a new thread and added information to it (is this enough?)
You can find it here:
http://forum.seemecnc.com/viewtopic.php?f=62&t=2492

Thanks' again,

Octavio

Hello Everybody, I finished assembling my Rostock MAX just recently and I have not been able to get a good piece out of it. I'm testing it with the hallow cube and after millions of different problems (blown thermistor, ABS not sticking to the heated bed, heated bed not reaching the 90˚ temp) now I' ...

Hello Everybody, I finished assembling my Rostock MAX just recently and I have not been able to get a good piece out of it. I'm testing it with the hallow cube and after millions of different problems (blown thermistor, ABS not sticking to the heated bed, heated bed not reaching the 90˚ temp) now I' ...