Welcome to the SeeMeCNC Community

hi ;

seems this is a common trouble for large objects sliced via Cura, i faced similar incident when trying to print 15cm height model. i kick my head on trying and trying to play around with the GCode on the stooping point, nothing succeed.

did any body find a solution for this,

Hello Friends;

just to update you on my Heat Bed Issue, after reviewing almost all the Forum Comments. the best idea was to supply another PSU to Heat Bed. I did it , its working fine now, no noticeable problems.

hope it will remain that.

Thanks

Thank you all for that, yes you are right i am over passion to get start :D but as per manual, i reached a point where to calibrate the access and to test movement. even i didn't print any single part . so am wondering about the overheat disconnection. i will follow Eaglezsoar advice and re look for ...

thanks Eaglezsoar, i am using the latest 0.90 C Version,

its responding to the IDle commands, but still repeating the messages . also another problem pops up when trying to heat the bed and the hot end, suddenly the printer switched off ... any body faced similar incident ?

Hi everybody, am new to this forum and even to 3d printing world, i just finished assembling my Rostock Max kit. it took me 1 week to finish it :cry: after installing repetier host and upgrade Firmware, i followed the manual to start calibrating the parts. when connecting to the machine, the ...