Welcome to the SeeMeCNC Community

I finally have y printer running but I am having issues with my extrusions not connecting together infill and perimeter all have a slight gap between each width. What settings do I look at to fix this? I already measured and set the filament diameter.

Thank you. I figured that out a little later and disabled the end stops and that worked. Now I have an issue that my z axis moves what appears to be one cm when told to move one km. X and y appear to be accurate. Where can I make adjustments in repetier for movements? I can only figure out how to ...

It appears I cant get the motors to move up on any axis and that is the issue. I have tested the motors with the the drive individually using just the standard Cartesian configuration and the motors will spin in both directions without issue. So i know its not a wiring issue or mechanical.

Hello, New here, just finishing up my Rostock build. I am having issues with my arms not moving correctly, an x or y move will result in the axis moving in one direction as well as in the z direction always in a down motion. Attempting to move up in the z direction results in a buzz noise while ...